2
LIST OF CONTENTS
Kickspace 1
Radiator 1
Radiator 3
Room
thermostat 2
Kickspace 2
(manual control)
Fig. 1 - System design
1. Application ............................................................... Page 2
2. Electrical Supply ................................................................. 3
3. Preparation ......................................................................... 3
4. Water Connections ............................................................. 4
5. Fitting Kickspace ................................................................. 4
6. Completion .......................................................................... 5
7. Controls ............................................................................... 5
8. Operation ............................................................................ 6
9. Maintenance ....................................................................... 6
10. Technical Data .................................................................... 6
11. Wiring Diagrams ................................................................. 7
1. APPLICATION
1.1. System design
Kickspace 800 fan convectors must always be fitted to a two pipe pumped circulation central heating system.
For optimum performance, fan convectors require a continuous flow of hot water through the high efficiency heat
exchanger. If used in conjunction with radiators it is preferable to provide a separate circuit for the fan convectors to
ensure an adequate flow of water in accordance with the technical data given in section 10 (page 6).
Fig. 1 shows an example of a system combining fan convectors and radiators. The pump runs continuously while the
system is in operation.
The fan convectors may be controlled by individual room thermostats, and the radiators may be controlled by one or
more zone valves via room thermostats, or by individual thermostatic radiator valves.
Systems with thermostatic control which switches the circulating pump will affect the fan convector function as the flow
of water will be interrupted.
If a separate circuit cannot be provided for the Kickspace, its position should be chosen, and the system should be
balanced, to ensure sufficient water flow is provided. Low water flow will be indicated by the unit switching off by its
internal water temperature thermostat when the fan and pump are running together.
1.2. Selection
It is preferable to select on the basis of maintaining the calculated heat losses of the room when operating at Low fan
speed at 60°C temperature difference. This will enable the Boost fan speed to be used for more rapid warming from cold
in extreme conditions.
The mean water temperature should not be below 60°C for satisfactory operation.
1.3. Location
Kickspace 800 units are intended for installation in the cavity beneath cupboards on the vacant floor space. In this
position, consideration should be given to the storage of perishable goods in the cupboard above.
No rear access shall be available to the unit after completion of installation.
Boiler
Radiator 2
TRV
Room
thermostat 1
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals